Photo Gallery (3 photos)

Call for price

For businesses that have extraordinary heat needs and sufficient quantities of waste oil the F450 furnace is their answer. This unique design features a fire down configuration of the burner and all heat exchanger surfaces are vertical to prevent the build-up of ash. This extends the time between cleaning. The heat exchanger tubes are separated into heat zones allowing for independent expansion preventing stress fatigue on the steel. Like our other furnaces, it is fully cleanable and very energy efficient. In addition this furnace comes with a squirrel cage blower to allow ducting to distribute the hot air. The F450 will heat up to 10,000 square feet while burning 3.78 gallons per hour of waste oil.

• FEATURES
  • Tested Fuels
    • Grade 2 Oil
    • Used Crankcase Oils
    • Transmission and Hydraulic Oils
    • Crankcase Oil with 10 percent gasoline
    • 90 Weight Gear Box Oil
    • 175 Weight Heat Transfer Oil
    • Mineral Spirits Solvent
    • Machine Shop Cutting Oil
    • Vegetable Oils

  • Additional Fuels
    • Synthetic Oils
    • Commercial and Military Jet Fuels
    • Grades 1, 3 and 4 Heating Oils

  • Industrial Safety Controls
    • Fireye Combustion Control
    • Ultra-Violet Flame Detector
    • 90 Second Pre-Purge
    • Continual proof of atomizing air
    • Continual proof of combustion air
    • Safe Start Sequence
    • 10 second Trial for ignition timing
    • 3 second Flame failure response timing
    • Safety shut down indicator
    • Fuel shut-off by electrically operated valve and mechanically driven needle into oil nozzle
    • Line voltage thermostat controlling all burner power

• SPECIFICATIONS
  • Dimensions (l x w x h) : 55"/79" x 40" x 40"/54"
  • Stack
    • Inches of Diameter : 8"
    • Height(without elbows) : 14'
    • Draft(inches of water) : -0.03 to -.04
  • Compressed Air Requirements
    • SCFM : 2
    • PSIG : 30
  • Air Connection : 1/4 NPT
  • Flame Length : 4'
  • Flame Diameter : 18"
  • Mounting Flange : Standard 3 bolt pattern
  • Diameter of Air Tube : 5"
  • Length of Air Tube : 4-1/2"
  • Opening for Air Tube : 5-1/4"
  • Convenience Controls
    • Additional attempts to establish flame
    • Automatice nozzle clean-out
    • Hour meter
    • Dirty filter indicator
    • Switch to test spark ignition
  • Cabinet Construction
    • Material gauge, aluminum : 14
    • Weight : 850 lbs.
  • Furnace Air Movement via Prop or Squirrel Cage Blower
    • Blower Motor : 1-1/2HP
    • Capacity-CFM : 4,000
    • Motor Speed : 1,725 rpm
    • Outlet Openings : 36" x 35"
  • Electrical
    • Total current draw-max : 17
    • Volts : 120
    • Required circuit protection : 20 amps
    • Frequency : 60Hz
    • Thermostat Voltage : 120
    • Ignition Transformer, 23 ma secondary, continuous duty shielded transformer : 10,000V
    • Intermittent spark ignition : 10 seconds
  • Burner Motor
    • Horsepower : 1/5
    • RPM : 3,450
  • Fuel Pump : Sunted Model A2RA Waste Oil Pump
  • Oil Nozzle : Delavan Aspirated Nozzle - 30609-5
  • Equipment Provided
    • Vapor elimination from oil
    • Filtration after oil heating
    • Heater switch
    • Line voltage thermostat
    • Barometric damper
    • Floating oil pickup assembly
    • Check valve
    • Return flow vent system
    • Installation and Maintenance Manual
  • Warranty : 1 year full warranty on parts (not labor), 10 yr limited on furnace cabinet