The NEW 5000 Brake Lathe
Variable Speed Gearbox

Double the Speed of your Ammco Lathe!

Turn your rotors and drums faster and get a better finish "In One Cut"

This new product is designed to offer you everything you would have to pay upwards of $4,000 to get...But allows you to do it at a fraction of that cost. If you have been considering purchasing a new lathe because your old one is being used to capacity or just because it doesn't have the variable speed function...think again! Upgrade that old Ammco lathe and bring it into the 21st century with our all new, very impressive Variable Speed Gearbox!

Features Cuts rotor in less than 2 minutes Offers variable speed control Improves lathe performance Produces a better surface finish

The 5000 Gearbox has less than 20 parts for easier repair and less opportunity for breakdown. The innovative design turns the lead screw nut, not the shaft, reducing wear on the cross feed casting and lead screw shaft. This reduces friction and vibration for a smoother cut and greater productivity. Best of all-the the 5000 Gearbox easily bolts to your existing lathe without permanent modification or costly, time consuming installation.

Gearbox Installed on Ammco 4000 Lathe. No Special Tools or Modifications Needed. Simply replace your existing gearbox and pulleys with the new ones for greater productivity, power, and profitability. The 5000 comes complete with controller, gearbox, pulleys and a self-contained motor to avoid robbing power from your lathe. Our free videotape walks you through the easy, step-by-step installation.

Offering twice the pulling power of the old Ammco pulley system, these pulleys are so smooth running that lathe vibration is almost eliminated! The easy to install pulleys and Poly-V belt system increases arbor speed from 150 RPMs to 200 RPMs to boost productivity. Normally used in 5 hp applications, it will not slip when adjusted properly. Poly-V belts and pulleys are sold separately to allow upgrade of Ammco 3000, 4000,4100or 7000 for a smoother, faster performance. Pulleys may also be used effectively without the 5000.

The controller offers greater speed variety - from Ammco`s fastest to as slow and fine a finish as you desire - with all the wide range of speeds in between. Simply slow down the controller to reach true one cut capability or increase the speed to raise productivity. Vary the depth to accommodate speed changes. Handle it all - usually in less than 2 minutes.

Specifications

Motor	Voltage	Weight	Height	Width	Depth
1HP	110	18 lbs	10"	5"	9"